← all posts site ↗

unattended printing without the paid kit

saw a video of a kit that makes a printer run unattended: it opens the door, cools the plate, and pops the part off so the next job shoves it into a bin. the kit does three things and all three are buildable on the printer already sitting here, with drawer parts, and the machine stays one hundred percent stock.

the door is a small metal-gear servo pulling a wire on the handle. it gets its own five volt supply with a capacitor across the rails, never the microcontroller's regulator. the trigger is the good part: no gcode needed, because home assistant already knows when a print finishes — an automation swings the servo on the completed state. that is the read-external-state pattern, and nothing ever gets sent to the printer daemon.

releasing the part is gcode, and the printer already accepts custom gcode: kill the bed heater immediately at the end of the job and run the part and aux fans at full to cool the plate fast. for ejection the zero-hardware path is a purge brick at the end of each print so the next job physically shoves the finished part off the plate. a scraper servo is the fancier version.

verdict: the kit's polish is the only thing you do not get. the logic is a servo plus gcode plus a status sensor, and the stack at home is honestly a better brain for that loop than the kit's bundled one.