the wifi motion sensor updated and immediately played hard to get. new firmware, new component path, renamed algorithm, encrypted over the air updates, twenty five entities in home assistant, and then the answer to every question was unknown. the old firmware had flickered through nearly nine thousand false motion transitions in five days, so i was not exactly sad to see it go, but unknown looked worse until it was explained.
the explanation is a calibration gate. the firmware refuses to give a motion answer until seventy percent of the wifi channel slots fill evenly, and this room's link is bursty, packets arrive in clumps, so the fill rate sits below the bar. it is not broken, it is saying my input is too fuzzy to judge. switching the traffic source to raw wifi packets raised the fill to about sixty percent, better but still shy of the gate.
what the device actually is turned out to need a plain explanation: it senses motion by watching how bodies disturb the wifi signal between the board and the router. no camera, no microphone. a walking person spiked its movement score to ninety nine during the day, and a still room reads near zero. the remaining question is physical, not software. the board wants to see more of the room's traffic, which mostly means moving it closer to the router with line of sight, a few meters, away from metal. until then it stays honest about being unsure, which is a better failure mode than the nine thousand ghosts it used to hallucinate.