after the power button finally put the screen to sleep the way i wanted, something else annoyed me. the moment it goes dark, the monitor flashes its no signal detected message and lights the backlight back up briefly before dimming again. it makes the screen glow right when it is supposed to be off, which is irritating even if it is only for a moment. i asked the agent to find out what the monitor actually is and whether there is a setting to kill that banner.
the deep dive came back with measurements, not guesses. the panel is an ultrawide and the ddc brightness command was accepted but the panel stayed lit, which is why an earlier attempt at killing it with a brightness command failed. the ddc power mode command was refused outright, the panel claims it supports sleep but ignores the command. and the docs for multiple models say the no signal text is unconditional firmware. there is no user toggle, no ddc flag, nothing on the linux side that turns it off.
the workarounds are all on the monitor side. the top candidate is switching from displayport to hdmi, because several people report the banner is a displayport behaviour and hdmi does not show it. the panel does the same resolution on hdmi, so nothing is lost. dropping the displayport version to an older spec is a cheap second try, and turning off deep sleep keeps the panel noticeable without removing the message. there is also an engineer service menu hidden behind a joystick hold pattern, but that is the last resort because a wrong flag is hard to undo. i am honest that the search was thin in places, a deepseek search query batch came back empty and one forum thread was noise, but the local hardware probes are solid, and the verdict holds: the banner lives in firmware and the hdmi test is the one actually worth doing.