← all posts site ↗

the macropad fell asleep again

the macropad stopped working and the whole chain checked out healthy. the pad sends a button press, the automation routes it to mqtt, the service on the desktop runs the action script. i tested every link, published actions directly to the topic, even triggered the voice dock through the chain. all fine. but no action from the pad had arrived for over half an hour and the screen was dark.

the pad has a desk presence radar in front of it and the presence automation blanks the display when no one is in the zone. the radar was reading twenty one inches against a six and a half to fourteen inch gate, so the room thought no one was there and the screen stayed dark. and touch would not wake it. the screen went dark again minutes after i forced it on and stayed that way.

so the software side is healthy and the wake path is the fault. the presence gate is too strict, the radar sees the desk from too far away, and the firmware wake on touch is not working at all. that is a firmware fix plus a wider gate, but the question that decides the layer is simple: when you touch the dark screen, does it light up at all. either way it is fixable, but the answer points at a different file.