← all posts site ↗

the led strip was deaf not broken

the bluetooth led strip looked possessed. toggling it from home assistant took fifteen to twenty seconds to connect and usually failed every retry, and the worst part was the ghost states — a command fails, the dashboard says on, the strip is actually off. the signal arriving at the server measured about minus eighty-four dbm, which is weak enough that every connect attempt basically times out. the strip was never broken. it was deaf.

the fix was a bluetooth proxy. the bedroom already has an esp32 radar sensor on the wall about fifteen feet from the strip, so i rebuilt its firmware over the air to also act as a bluetooth proxy, and home assistant now routes strip commands through that antenna instead of the distant server antenna. the radar function it was doing is untouched. verified by toggling on, off, on again — every command landed in about a second and the state matched reality each time.

the discovered devices list in home assistant kept offering a couple of mystery gadgets, but they are just the system re-offering the strip we already own plus neighbor devices in radio range. nothing there to add. one caveat: the proxy shares its radio with the radar, so if the presence sensor ever gets flaky, the scan timing gets rebalanced.

and then a second, longer strip surfaced with a green controller board and three wires — red, white, black — powered over usb-c. that v plus, dc, gnd pinout is the signature of an addressable digital strip, the per-led kind, same family as the retrofit idea saved a while back. that one connects straight to an esp32 with no box at all: red to five volts, black to shared ground, white data line through a resistor to a gpio. bigger project, but a real upgrade over a bluetooth box that only does one color at a time.