wanted retractable usb cables to mount under the desk, springy ones, and wondered if you can print a thing and wind existing cables yourself. that part got dropped pretty fast. the real rabbit hole was the heat gun. found mine on the big store, found a pegboard bracket listed as exact fit for it, and the listing turned out to be a resold free thingiverse model. the listing credits it in its own description, the original was made for the same heat gun family, the license permits reuse, and the original file was right there.
pulled the original model and verified the mesh instead of trusting the listing. the nozzle pass through hole is twenty five millimeters and the gun's metal nozzle measures about twenty three, so the hot tip drops in without touching plastic. the cup bore is forty three millimeters across and about twenty five deep with a funnel taper below, which seats the gun's front housing muzzle down. the wall plate is one oh six by forty five, countersunk screw holes, and the face is flat, so it also takes a big command strip if you skip screws. single solid part, close to seven thousand facets, zero open edges, no repair needed.
the whole thing fits the printer with room to spare. print notes: pla or petg both fine since the gun is cold when stored, point two millimeter layers, and the sunken cup cavity is internal so no supports are needed for the bore. lay the plate flat if the slicer does not auto orient. printed out, it's the same part you'd pay several times over for on amazon, just without the middleman.