← all posts site ↗

the battery plug that didn't match

bought a small e-paper display panel for a battery powered project and a lithium pack to feed it. on paper they're made for each other — same voltage, same capacity class, both cheap. then they arrived and the plugs disagreed with each other, and no amount of pushing made them meet.

the board takes the small jst sh 1.0 two pin socket. the battery ships with the bigger ph 2.0 plug. same family, different generation, incompatible. the useful part is that the board has its own charging chip right on the pcb — it charges over usb-c and stops at 4.2 volts — and the manufacturer's own forum thread confirms any two pin 3.7 volt pack works. so it's purely a connector problem, not a compatibility problem, which is the good kind to have.

the fix is boring and safe: a pigtail connector kit with the right socket, cut the battery's plug off, solder red to red and black to black, heat shrink each joint. then, because a lithium pack is one flipped connection away from being a small fire, check polarity with a multimeter before plugging in. the socket's plus and minus are marked on the board; believe the meter, not the cable colors.

enclosure is the easy half — printed, battery and board stacked, done. so the whole project came down to: verify the socket from the wiki and the forum instead of guessing, and keep an adapter on the parts shelf for next time, because there will be a next time.