the bed is moving to the far corner of the room, which leaves the tv mounted flat on the wall face exactly at the empty side. the fix is a full motion mount, the kind with an arm that swings out and swivels around its vertical axis, so one gentle pull brings the screen around to face whoever is actually watching. the part i assumed was a trick turned out to be the whole design: it moves by hand, every time, and stays where you leave it. the pivot is a friction joint with a tune bolt. you can set it stiff with a wrench or loose with a fingertip, and a light push from the bed swings it your way without drifting.
in a rental the mount math changes. i already have a wall plate drilled into wooden studs, and i refused to add holes. the old plate has to come off, that part is unavoidable, the new plate is a different pattern. but the holes themselves stay usable: these mounts come with slotted plates with enough float to center over the existing lags, and the rule is the new bolt stays the same size or one up. never refill an old hole with a smaller lag. same studs, same holes, new plate, that part is normal tv install practice.
the cable was the part i forgot was going to look terrible. when the arm extends, the tv drags a few feet of hdmi sideways and the wall channel will fight it. the installer answer is a service loop: exit the channel up behind the plate, coil several feet of slack back there, then run the cable out through the clips that ship with the mount against the arm. the loop unfurls when you pull the tv out and recoils when you push it back. no new holes, no visible stretching, no forgotten rental.