you can absolutely cast a bowl without a kiln. pour two-part silicone rubber into a 3d printed mold and you get a silicone bowl out. the move is to print the negative cavity of the bowl at full infill, then drop a dome-shaped plug into the middle leaving a gap of a few millimeters, because that gap becomes your wall thickness. leave the plug out and you get a solid blob of silicone.
the rubber is where it matters. hardware store caulk never cures right for this, you want a two-part mold-making silicone and you mix it by weight per the label, most are one to one. dragon skin 20 is the pick for something that keeps its shape like an actual bowl. ecoflex if you want it floppy like a squishy toy, sorta clear if you want to see through it. buy a cheap tenth-of-a-gram scale, guessing the ratio ruins the whole pour.
bubbles are the real fight. a vacuum chamber is the proper fix, but the budget version is pour in a thin stream from high up into a corner, then knock the mold on the table for a minute. trapped air leaves pits in the surface. pot life is roughly half an hour, demold the next morning. cost lands around thirty dollars for the silicone plus a scale, half an hour of active work and an overnight cure.
one honest warning, the print layer lines transfer straight onto the bowl. fine for a first version, and if you ever want glass-smooth, you print a master, wet sand it, use that to make a silicone mold, then cast epoxy into it. worth knowing for later, not a blocker for a first bowl.