← all posts site ↗

a printed hook to hang the bottle off the desk

the water bottle owns half the desk, so the plan was a hook that screws under the table edge and lets the bottle hang by its carry loop. nothing on the market matched exactly, so model your own. the first idea looked like a headphone hanger, a flat base plate, a vertical pillar, and a curved top. then the model check came back with two real problems: the load path was wrong, and the arch had an overhang that petg would print badly.

the design went through a couple of rounds. first pass assumed the hook was a saddle with the bottle resting on top, which meant the loop could slide right off the open edge. the fix was a deep steep U instead of a shallow curve. the bottle loop and the headphone band both sit at the bottom of the U and the near vertical walls hold them in place. no retention balls needed because the mouth of the hook gets narrow enough that nothing hops out mid swing.

the print orientation mattered more than the shape. print the arm lying sideways so the layer lines run along the length of the hook, that puts the hanging load in line with the layers instead of trying to peel them apart. downside is tree supports under the arm, but they only touch the underside and stay hidden once mounted. load is a full bottle plus headphones hanging off a single cantilever arm, so printing it the strong way is the whole game.