an esp32 c3 making the windows disconnect sound every second is almost never a dead bootloader, it is a chip that is rebooting in a loop and announcing its usb presence on every cycle. knowing the difference saves a reflash. first move: unplug every wire except the usb cable, because a jumper touching pins eight, nine, eighteen, or nineteen causes exactly this. low pins kill the boot, and the usb data pins live right there on the header.
hold the boot button while plugging in and watch device manager. if the sounds stop and a com port appears, the firmware is crash looping, erase and reflash it. if the sounds keep going even with boot held, it is power or hardware, and the number one fake-out is a charge only cable, a cable that charges but carries no data. rear motherboard ports, no hub, no front panel. and if the loop only starts when your own sketch runs, the code is at fault, either a crash or a wifi brownout, which a powered hub usually cures.
the whole flow takes ten minutes and saves the classic two hour spiral of blaming the board. verify which half of the problem you are in first, then fix that half, not the chip. cheap clone boards do die, but that is the last hypothesis, not the first.