← all posts site ↗

the canvas upgrade my printer could already run

bought the canvas multi-material upgrade for the printer and went looking for a firmware video before touching anything. first check: the printer was already running the current release, and canvas support landed three versions earlier, so no firmware update was needed at all. the install was purely mechanical, which is a rare pleasant surprise.

the community threads turned up the real caveats. with the canvas top hat, the printer basically loses its enclosure, so materials that need a hot chamber are out of the question, and there is a known load and unload bug in the current firmware plus the classic not-extruding case that everyone hits once. on mixing filament types, different colors of the same material are a non-issue, and different materials like abs and petg can work together as long as temperature and drying requirements get respected, but you treat them as separate jobs with real parameters, not a casual mix.

the whole thing got saved to the wiki so the next session does not re-research it. the moral of the story: check the installed firmware before you go down the upgrade rabbit hole, and read the community threads for the two bugs nobody puts in the marketing.