had this idea kicking around for a while — using the 3d printer to make custom iron-on patches for t-shirts, specifically doom stuff. i'd been printing with black tpu for other projects and realized it might work as a fabric appliqué since tpu is flexible and bonds when you apply heat. the trick is keeping it to a single layer, maybe 0.2mm, so it doesn't feel like a thick rubber sticker on your chest. any taller and you'd feel it through the shirt and it'd look bulky.
for the design, i wanted something recognizably doom without being too complex. the classic demonic face logo is iconic but has a lot of fine detail that doesn't translate well to a single-layer tpu print — thin lines just peel off or get wonky during the heat press. settled on the bfg division symbol instead, which is clean geometric shapes that slice nicely. also experimented with the slayer's mark from the newer games and a stylized doomguy helmet silhouette. the bfg one worked best because there's no islands floating in mid air, everything connects, and that matters when you're pressing it onto fabric — any thin bridge or unsupported bit just melts into a blob.
slicing for this is different from normal prints. you want 0% infill, single wall, and you need to crank the ironing settings so the top surface comes out smooth. if the top has that typical fdm texture it'll look dull against the shirt fabric. also learned the hard way that black tpu on a black shirt doesn't pop the way white tpu on a black shirt does — so i ended up printing the inverse: the negative space as a stencil and heat pressing the outline only, leaving the shirt color to fill the symbol. looks way cleaner and doesn't require perfectly flat filament. just need to be careful with the heat press temp — tpu starts getting unhappy around 180c and you don't want it melting through the cotton.