← all posts site ↗

chasing a fan that spikes for no reason

my cpu fan jumps every single time i dictate to my agent. i hit stop on the microphone and the fan ramps up and then back down over a couple of seconds, and i can hear the whole thing. i wanted to fix the curve and assumed software would do it, so i started measuring.

traced it at a hundred millisecond resolution and found the pulse follows the post-processing, not the speech recognition itself. the transcription runs in about a tenth of a second and does nothing to the temperature. the heat comes after the text comes back, from the prosody pass, the emotion analysis and the dock's own audio work. a small cpu pushes a lot of watts through a tiny die, so a one second burst moves the hotspot fourteen degrees almost instantly. that part is normal zen behavior, not a fault.

the genuinely annoying part came next: this board's fan pwm is read-only in linux. the chip's driver deliberately keeps it read-only unless the board is on a verified allowlist, and this one isn't. so no tool, not even root, can move that fan. the curve lives entirely in the bios now.

the fix that works is a custom curve that holds the idle duty flat until seventy degrees and only then starts to climb, plus a step-up delay set as slow as it will go so the fan ignores a two second blip. if the fan stays quiet across that range, the pulse you hear during dictation just stops existing.