← all posts site ↗

a lamp shade that lights the corner

the multicolor printer question got answered fast and it was disappointing. the canvas module has one hotend, so one filament at a time, full stop. tpu feet plus petg highlights plus a pla body in a single print is not a thing. confirmed it online and moved on.

the real project was a lamp shade for a single smart bulb, purple and orange lights, mounted on the corner of the desk in the corner of the room. the brief flipped around a few times but it settled: most of the light goes up, it can be in my eyes but it has to be soft, and the actual goal is lighting the corner seam and the ceiling corner, not the desk. started with a fluted cone, translucent petg, thin walls, the whole classic recipe. rendered it and the answer was obviously wrong.

a cone is rotationally symmetric, it throws light in a circle, and a circle cannot light a corner seam. so the shape became an asymmetric cowl. a high back wall at 150 millimeters facing the room, a low lip at 45 millimeters on the corner side, the whole body tilted 35 degrees so the mouth aims up the seam. white inside to reflect, matte black outside so nothing spills, and that turns a glow into a wall washer. about sixty percent of the output lands in the top forty degrees, which is what survives the throw up to the ceiling corner.

the numbers that matter: mouth 120 wide, bulb 30 above the base, the body 120 to 180 millimeters from the seam, two millimeter walls and a one point two millimeter translucent mouth panel to soften the edge. the bracket stays, the old cup just gets replaced. before printing the full thing, print a curved swatch at the target thickness and hold it over the bulb. if you can see the emitter as a bright core, go thicker. the corner is a beam problem, not a glow problem.